Property / Permits← Search
Rochester, MN
906 NE 16 ST
Search
Permits
Rochester, MN
906 SW 17 AVE, Rochester
-Plumbing work for single family home -Kitchen remodel -Move fixtures for dishwasher, sink, & ice maker -Add fixture for pot filler -add island vent to existing vent -add island drain to existing drain water heater replacement remove existing tankless water heater and install new. vent clothes washer
906 SE 9 ST, Rochester
Power has been turned off to this residence. This is inspection is to get power tuned back on. I looked over the electrical service. I installed blank covers over the open spots in the service panel. I grounded the water main and bonded around the water meter. I installed the panel cover on the garage panel.
906 SW 17 AVE, Rochester
Kitchen remodel | Other
4906 SW SCENIC VIEW DR, Rochester
Furnace Replacement
906 SW 11 1/4 ST, Rochester
Bathroom Remodel with Mad City RPH13748
906 SW 17 AVE, Rochester
Mechanical - add 1 return, has existing supply routed through 6" diffuser Basement bedroom remodel; egress window
906 SW 17 AVE, Rochester
Electrical - adding 6 outlets and moving 1 light switch Basement bedroom remodel; egress window
906 SW 17 AVE, Rochester
Basement bedroom remodel; egress window | Basement Finish
906 SW 11 1/4 ST, Rochester
Bathroom remodel | Other
906 SW 11 1/4 ST, Rochester
Tub replacement
906 SW FOX CHASE RD, Rochester
Radon Fan
906 NE 19 ST, Rochester
Wire Furnace
906 NE 19 ST, Rochester
Install Furnace
906 NE 16 AVE, Rochester
Existing duct work dips below floor joist to connect to main level living room. To allow maximum height for finished ceiling, plan to re-route duct within neighboring mechanical room so it runs between floor joists. New duct work will include an additional heat vent to ceiling in basement family room.
906 NE 16 AVE, Rochester
Existing copper pipe in basement runs below floor joists. To maximize finished basement height, plan to replace existing copper pipes in basement living area with PEX and re-route PEX between floor joists from living area to mechanical room. Also plan to replace copper pipe to kitchen and exterior with PEX.
906 NE 16 AVE, Rochester
Existing wiring is attached to bottom side of floor joists. Plan to replace wire to all outlets and light fixtures with 12-2 wire with ground and re-route to between floor joists. All new wiring connected to junction box and then 20amp breaker in neighboring mechanical room. Install new can light fixtures in main living area. Install new closet light fixture.
906 NE 16 AVE, Rochester
Basement finish with family room | Basement Finish
3906 NW HWY 52, Rochester
INSTALL VENT FOR DRYERS
906 NE 19 ST, Rochester
Electrical work for remodel bathroom, move switches, add sub panel
906 NE 19 ST, Rochester
Bath remodel | Other
906 SE 8 AVE, Rochester
Replace 40 gallon atmospheric water heater. Harris Job # 274989
4906 NW 21 AVE, Rochester
A/C replacement
2906 SW 15 AVE, Rochester
Installing whole home service rated transfer switch and standby generator
1906 SW BRITT LN, Rochester
Building a new 31'x16' deck. | Deck Addition
2906 NW 17 AVE, Rochester
Electrical AC
Data sourced from Minnesota Department of Labor & Industry, Minnesota Attorney General, federal OSHA, and municipal permit offices. Records are public and may not reflect pending appeals or corrections.