605 15 ST S

Replaced damaged NM wires to ceiling smoke detectors and replaced unit feeder panel. Installing all new device and lights on upper level of apartment unit.

J8591 Range hood receptacle

Bath Fan & Fin Tube Baseboard replacement

Fire Damage plumbing remodel

Removing sheetrock and insulation in unit 303 down to studs on exterior walls, floor/ceiling, interior unit separation walls and interior walls inside the unit itself. This permit is for demolition work only; separate permits are required for re-finish work. Any work completed beyond the demolition prior to re- build permit issuance may result in stop work order posted and investigation fees applied to the re-build permit price.

New single family residential build, split entry with finished basement, 5 bed 3 bath

Remove/Replace flawed sewer main in the back yard of the home.

New home construction, and installation of water and sewer.

Replace Furnace and AC

WIRE BATH FAN

Added light in compressor room, added light in back loading dock room, added exit and emergency lights in East warehouse, added 2 tv outlets in showroom, added showroom outlet by front window, added 3 outside lights and 1 switch, wired fork lift charger, wired exterior signs, added 2 office outlets, wired air compressor, wired 1 overhead door, wired new dock leveler.

Remove existing signs on the South and West elevations of the building and replace with new LED illuminated single sided wall signs

Run power from existing wall pack on (front) South elevation, approx 10 feet, to new illuminated 4' x 4' "Zeiss" wall cabinet. Run power from existing wall pack on (left side) West elevation, approx 12 ft, to new illuminated 4' x 4' "Zeiss" wall cabinet. Complete final connections to both cabinets.

Remove and replace roofing on house and attached garage

WIRED DETACHED SHED

Remove and replace 1 window in Upstairs Bedroom and 2 Patio Doors in Main live and basement of same size and type into original openings

NEW 30X56X60 ACCESSORY BUILDING

RECONNECT OUTSIDE LIGHTS AND OUTLETS

Remove existing EPDM, BUR and insulation down to the existing deck. Mechanically fasten 2 layers of ISO insulation to meet R- 30, and install a fully adhered EPDM roof system.

Reside/TO House Only

Reroof/TO & Reside/TO House & Garage

Reroof/Tear-off House, Garage & Additional Outbuildings

Reroof/Tear-off House & Garage

Reroof/Tear-off House Only