Mechanical

InspectorChris Weaver

CORRECTIONS MADE

InspectorChris Weaver

---TAPE HRV ---NEED TRANSFER GRILL FROM BATHROOM TO MAIN AREA FOR GAS DRYER ON 1ST AND 2ND ---INSULATE HOT WATER LINES IN GARAGE MECH ---BOILER NEEDS T AND P VALVE PIPED 18" OFF FLOOR HRV BALANCED, MANOMETER ON ENTIRE SYSTEM OK, ALL TERMINATIONS OK

InspectorMarshall Lind

1. Need 10 ft separation between air exchanger intake & furnace exhaust, 2. Need to label all intakes & exhausts, 3. Direct vent Furnace exhaust/ intake must meet manufactures installation instructions, 4. Need manometer test, 5. Need to balance & label air exchanger, 6 Need locking caps on AC, 7. Need to check all bath fans, No kitchen hood installed at this time CANNOT VIEW NAIL PLATES ON DRYERS, CANNOT VIEW INSULATION & VAPOR BARRIER ON DUCT WORK IN GARAGE CEILING

InspectorChris Weaver

---HRV INTAKE TOO CLOSE TO FURNACE EXHAUST ---BOTH DRYERS NEED NAIL PLATES 2" DOWN FROM TOP PLATE ---ALL GARAGE DUCT MUST BE INSULATED R8 AND VAPOR BARRIER DISCUSSED ADDITIONAL RETURN ON 2ND FLOOR, SPRAY FOAMING GARAGE DUCT, PLANS TO NET AND BLOW GARAGE CEILING, #30 AIR TEST OK ON ENTIRE MANIFOLD, ALL DUCT SEALED APPROPRIATELY